Maximum Criterion Manual de usuario descargar pdf (Pagina 1)

INSTALLATION

PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN

OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY, OR HARDWARE STORE

FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL WIRING BEFORE INSTALLATION.

Form a drip loop with the wire at least eight inches

below the exit from the sensor and at least eight inches

below the point of entry into the building. Anchor any

exposed wire with insulated cable clips. Run the wire

through the building to the location where the indicator

will be located. Caulk any holes when done.

Feed the AC adaptor's cord and the sensor wire to the indicator.

Connect the the two wires of the AC adaptor cord to the back of the

indicator with the supplied brass nuts. The polarity does not matter.

Connect the two wires from the temperature sensor to #1 and #2

screw terminals (reading #1 through #5, left to rignt). The polarity

does not matter. Do not plug the AC adapter in until all of the

connections have been made and checked.

Mount the temperature sensor assembly with the two

large wood screws. Select a location that is protected

from direct sunlight and sheltered. (A north exposure, six

feet above the ground will give the best results.)

DRIP

LOOP

WOOD

SCREWS

CAULK

CABLE

CLIP

MIN

TEMPERATURE

SENSOR

ADAPTOR

Mount the brass read-out directly over the cable

feed-thru-hole to avoid crimping the wire under the lip.

We recommend mounting the read-out on one of our

pre-drilled and centered panels. Plug the power supply

into a 110 VAC power outlet.

CABLE-HOLE

WAL

SCREW

PANEL

Page 1

30 Barnet Boulevard

New Bedford, MA 02745

(508) 995-2200

CRITERION

1 2 3 4

Indice de contenidos

Pagina 1 - CRITERION

INSTALLATIONPROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH

Pagina 2

OPERATIONTROUBLE SHOOTING The trend register needle can be set by turning the center knob on the indicator dial. Unplug the AC adaptor and remove th

Pagina 3

2 OR 3 SENSOR OPTIONSCRITERIONAs a factory installed option, the Criterion has the ability to be built as a two sensor instrumentor three sensor instr

Pagina 4 - Recommended Prevention:

30 SAMUEL BARNET BOULEVARD NEW BEDFORD, MASSACHUSETTS 02745 U.S.A.TEL. 508.995.2200 WWW.MAXIMUM-INC.COM FAX 800.989.2580Page 4RW E A T H E R

Comentarios a estos manuales

Sin comentarios

Maximum Criterion Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Instrumentos de medición Maximum Criterion. Maximum Criterion User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Maximum Criterion Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Instrumentos de medición Maximum Criterion. Maximum Criterion User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Maximum Criterion